PRODUCTS CENTER
Papua New Guinea Probing Blanket Detection and Calibration Fixture for M2 Complete Machine
1.Install a large horizontal disc fixed to a servo motor. The fixture includes the servo motor, its controller (supports external signals for angle/speed adjustment), and power supply.
2.Divide the disc into 20 equal parts (size marked in the schematic). At 3cm from the disc edge, each part is 6cm wide on both sides. Affix materials to each part: 1) white matte tile, 2) gray matte tile, 3) white glossy tile, 4) black glossy tile, 5) white wallpaper, 6) gray wallpaper, 7) black wallpaper, 8) striped wood flooring, 9) cement floor, 10) pure black short-pile carpet, 11) khaki short-pile carpet, 12) red short-pile carpet. We provide wallpaper/carpets; supplier provides others. All materials must be flush on the same horizontal plane.
3.Fix a sweeper tray above the disc. Drill a large hole at the yellow circle (marked in the diagram) to let the ground detector (at this position) illuminate the disc below, aligning with the 3cm-from-edge position.
4.After material installation, the distance between the disc surface and the sweeper's bottom shell is 10mm.
2.Divide the disc into 20 equal parts (size marked in the schematic). At 3cm from the disc edge, each part is 6cm wide on both sides. Affix materials to each part: 1) white matte tile, 2) gray matte tile, 3) white glossy tile, 4) black glossy tile, 5) white wallpaper, 6) gray wallpaper, 7) black wallpaper, 8) striped wood flooring, 9) cement floor, 10) pure black short-pile carpet, 11) khaki short-pile carpet, 12) red short-pile carpet. We provide wallpaper/carpets; supplier provides others. All materials must be flush on the same horizontal plane.
3.Fix a sweeper tray above the disc. Drill a large hole at the yellow circle (marked in the diagram) to let the ground detector (at this position) illuminate the disc below, aligning with the 3cm-from-edge position.
4.After material installation, the distance between the disc surface and the sweeper's bottom shell is 10mm.
Category:
Product Description
Required Materials for Functional Test Fixture Manufacturing
1.Empty PCB boards
2.Populated PCB boards (PCBs with components mounted)
3.Circuit diagrams (required if wiring is needed)
4.Detailed customer requirement documents
5.Special components (to be provided by the customer)
6.Gerber files (used for test point selection in professional computer software)
7.Working CAD drawings (for relatively complex functional tests)
Let’s Solve Your Test Challenge Together
Whether you need a custom socket, fixture, or complete solution, our engineers will review your files and design hardware that meets your exact requirements.
Copyright© 2025 Shenzhen LD Electronic Technology Co., Ltd.
